Certificates

Declaration "CE" of conformity

RESISTENCIAS TOPE, S.A declares that the heating elements are manufactured according  the Directive 2014/35/UE and that they incorporate the corresponding CE mark.

Quality Control Certification

The quality system of RESISTENCIAS TOPE, S.A has ISO 9001 certification.
The heating elements are manufactured according to standard EN-UNE 60335 (chapters 10, 13 and 16).
All the products pass several controls of quality during the productive process. Also, at the end of this productive process, they pass the following controls:

Dimensional control (according to tolerances established in the technical data sheet).
Electrical inspections:
  • Dielectric insulation (tested at twice the nominal voltage + 1000V. The leakage current should be below 0,75mA/kW between active parts and the earth.
  • Isolation (the isolation is measured applying 500V DC.)
  • Tolerance allowed (-5% and +10% of the nominal resistance value).
  • Visual inspection

All the products can be supplied with an inspection report showing the measurement and test values Resistencias Tope, S.A cannot be responsible for any electric immersion heater failure that can be attribuited to corrosion because so many factors are beyond our power to control.

 
Certificado ISO 9001
The quality system of RESISTENCIAS TOPE, S.A has ISO 9001:2015 certification. The heating elements are manufactured according to standard EN-UNE 60335 (chapters 10, 13 and 16).
pdf View certificates
 
Certificado ISO 9001

The environmental management system of Resistencias Tope, S.A is certified according to the ISO 4001 standard
pdf View certificates

 
 
CE
RESISTENCIAS TOPE, S.A declares that the heating elements are manufactured according  the Directive 2014/35/UE and that they incorporate the corresponding CE mark.
 
UL
Resistencias Tope products are developed and manufactured in accordance with USA and Canada Directives.
 
Ex
2014/34/UE EC Directive regulating equipment and protective systems intended for use in potentially explosive atmospheres. ATEX certification approved for all type of gas to suit zone 1 and zone 2.
pdf ATEX certificate for liquidspdf ATEX certificate for gas
 
U
ASME-"U" ASME VIII div.1 and div.2-ASME "U" Stamp. Certification for pressurized vessels manufactured in carbon steel and stainless steel.
 
PED
PED 2014/68/UE. EC Directive for pressurized vessels manufactured in carbon steel and stainless steel.

 

 
ABS

RESISTENCIAS TOPE, S.A. Has obtained the ABS Certification (American Bureau of Shipping) The main objective of ABS is to promote the safety of human life and properties as well as the protection of the natural marine environment through the development and verification of standards for the design, construction and maintenance of ships and offshore platforms.